readme.txt 2.4 KB

12345678910111213141516171819202122232425262728293031323334353637383940414243444546
  1. /*!
  2. \file readme.txt
  3. \brief description of using the I2C bus to write and read EEPROM
  4. \version 2022-05-30, V1.0.0, firmware for GD32F30x
  5. */
  6. /*
  7. Copyright (c) 2022, GigaDevice Semiconductor Inc.
  8. Redistribution and use in source and binary forms, with or without modification,
  9. are permitted provided that the following conditions are met:
  10. 1. Redistributions of source code must retain the above copyright notice, this
  11. list of conditions and the following disclaimer.
  12. 2. Redistributions in binary form must reproduce the above copyright notice,
  13. this list of conditions and the following disclaimer in the documentation
  14. and/or other materials provided with the distribution.
  15. 3. Neither the name of the copyright holder nor the names of its contributors
  16. may be used to endorse or promote products derived from this software without
  17. specific prior written permission.
  18. THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS"
  19. AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED
  20. WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED.
  21. IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT,
  22. INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
  23. NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR
  24. PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY,
  25. WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
  26. ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY
  27. OF SUCH DAMAGE.
  28. */
  29. This demo is based on the GD32307C-EVAL-V1.1 board, it provides a description
  30. of how to use the I2C bus to write and read EEPROM by interrupt. The access result
  31. will be printed by COM0.
  32. Procedures sequentially writes 256 bytes of data to the EEPROM from the 0x00
  33. address, and then the program sequentially reads 256 bytes of data from the
  34. EEPROM from the 0x00 address. Compare the written data and read data, if the
  35. same,"I2C-AT24C02 test passed!" will be printed, while the board of the four
  36. LED lights start flashing, otherwise "Err:data read and write aren't matching."
  37. will be printed, while the four LEDs light will on.
  38. P4 should be fitted to I2C and JP5 must be fitted to the USART port.