/*! \file usbd_conf.h \brief usb device driver basic configuration \version 2023-06-30, V2.1.6, firmware for GD32F30x */ /* Copyright (c) 2023, GigaDevice Semiconductor Inc. Redistribution and use in source and binary forms, with or without modification, are permitted provided that the following conditions are met: 1. Redistributions of source code must retain the above copyright notice, this list of conditions and the following disclaimer. 2. Redistributions in binary form must reproduce the above copyright notice, this list of conditions and the following disclaimer in the documentation and/or other materials provided with the distribution. 3. Neither the name of the copyright holder nor the names of its contributors may be used to endorse or promote products derived from this software without specific prior written permission. THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. */ #ifndef __USBD_CONF_H #define __USBD_CONF_H #include "gd32f30x.h" #include "gd32f303e_eval.h" /* define if low power mode is enabled; it allows entering the device into DEEP_SLEEP mode following USB suspend event and wakes up after the USB wakeup event is received. */ #define USBD_LOWPWR_MODE_ENABLE /* USB feature -- Self Powered */ /* #define USBD_SELF_POWERED */ /* link power mode support */ /* #define LPM_ENABLED */ #define USBD_CFG_MAX_NUM 1U #define USBD_ITF_MAX_NUM 1U #define USBD_HID_INTERFACE 0U /* endpoint count used by the HID device */ #define EP_COUNT (2U) #define USB_STRING_COUNT 4U /* endpoint0, Rx/Tx buffers address offset */ #define EP0_TX_ADDR 0x20U #define EP0_RX_ADDR 0x40U #define INT_TX_ADDR 0x50U #define INT_RX_ADDR 0x60U #define HID_IN_EP EP_IN(1) #define HID_IN_PACKET 8U /* base address of the allocation buffer, used for buffer descriptor table and packet memory */ #define BTABLE_OFFSET (0x0000U) #define USB_PULLUP GPIOG #define USB_PULLUP_PIN GPIO_PIN_8 #define RCU_AHBPeriph_GPIO_PULLUP RCU_GPIOG #endif /* __USBD_CONF_H */